STEP-MXO2 Development Board

 

The STEP-MXO2 Dev Board is a small, breadboard friendly 40-pin DIP form factor board built around Lattice MachXO2 FPGA. The board includes a USB-JTAG programming circuit, clock source,two digital displays, three RGB LEDs, four push buttons, eight LEDs, four switches, one hard-core SPI, one I2C, and basic I/O devices. These components make it a formidable, compact, platform for digital logic circuits and Micro32 embedded soft-core processor designs using Lattice Diamond development software. There are 36 Digital FPGA I/O signals (30 GPIOs, four dual-functional pins default to SPI interface, and two dual-functional pins default to I2C interface) that are routed to 100-mil-spaced through-hole pins so that you can integrate your programmable design directly into a solderless breadboard circuit. At just 0.72 inch by 2.05 inch, it can be loaded in a standard socket and used in embedded systems.

Continue reading “STEP-MXO2 Development Board”

STEP-MAX10 development board

The STEP-MAX10 development board presents a robust, portable and easy-to-learn hardware design platform built around the Altera MAX10 FPGA. The MAX10 FPGA is well equipped to provide cost effective, single-chip solutions in control plane or data path applications and industry-leading programmable logic for ultimate design flexibility. With MAX10 FPGA, you can get lower power consumption / cost and higher performance. If you are a starter to FPGA, the STEP-MAX10 FPGA Development board is your best choice.

Continue reading “STEP-MAX10 development board”

STEP-Baseboard development board

The purpose of the STEP Baseboard is to provide the ideal vehicle for learning about digital logic and FPGAs. The board integrates a verify of peripherals to maximize the expansion of the STEP MXO2/MAX10’s GPIO. The STEP Baseboard includes hardware such as 1.8 inch LCD screen, buzzer，Temperature Sensor, Digital&Analog conversion chip, rotary encoder, six 7-segments displays.

Continue reading “STEP-Baseboard development board”